Table of Contents
Advertisement
Recall the equalizer curve to be
adjusted.
Recall a factory curve or user's curve
(equalizer curve created and stored in
this unit by yourself (next page)).
(Refer to "Recalling a Factory Curve" on
page 16 and "Recalling a User's Curve"
on next page.)
A user's curve in which no equalizer
curve has been set (= flat curve) cannot
be adjusted with nuance control.
Press (4) or (W) side of buttons [5] to
apply nuance control.
Pressing the (&) side increases the
amount of compensation (increases the
difference between high and low levels.)
Pressing the (W) side decreases the
amount of compensation (towards flat.)
(Numeric display shows "—6 — 6".)
The nuance control can be applied
separately to the factory curves and
users Curves.
The condition after nuance control of
each factor curve or user's curve IS
stored as the setting value for than
curve. The next time the factory curve
or user's curve is recalled, the equalizer
curve after nuance control will be
recalled.
15-Band Graphic Equalizer
Adjustment
1. Press button [4] to switch to the graphic
equalizer mode.
Each press of button changes the mode
as shown below.
Fader/balance mode (page 14)
Nuance control mode (page 16)
Graphic equalizer mode
(Example: ROCK (F1))
2. Recall the equalizer curve to be
adjusted.
Recall a factory curve or user's curve
(equalizer curve created and stored in
this unit by yourself (next page)).
25 Hz to 16 kHz (2/3 octave/step)
next page.)
17
Advertisement
Table of Contents
