Table of Contents
Advertisement
7-3-2. Checking the Initial Setting
+ Initial setting: the following diagram shows which LEDs light,
when the power is turned on,
1)
Main unit side
Connect the power cable to an outlet.
STANDBY LED (red lamp lights.)
Press the POWER button.
7-4. DIGITAL VIDEO BLOCK ADJUSTMENT
7-4-1. SC Frequency Adjustment
(DV-11 Board)
Mode
EE
Signal
Color bar S video
Measurement Point
1C301, pin 19
Measuring Instrument
Frequency counter
Adjusting Element
CV302
Specified Value
4,433,619Hz + 10Hz
Adjusting method:
1)
Connect the cable from the $ video output of the color bar
y
generator to INPUT (LINE [A |/[B ] S video terminal).
STANDBY LED (red lamp goes off.)
2) Adjust it with an adjustment driver.
POWER LED (green lamp lights.)
7-4-2. PLL Adjustment (1)
(DV-11 Board)
2) Contollerside
Mode
re
Signal
Color bar S video
renee INPUT
ine a [i] MIX
VIDEO [IX]
Measurement Point
TP301
Open the lid,
Adjusting Element
CV301
LINE A
NORMAL]
AUDIO
[NORMAL]
Specified Value
2V +0.2V DC
LINEB —!" (ORANGE)
(ORANGE)
7-4-3. PLL Adjustment (2)
(DV-11 Board)
Note:
If [OPTION], [START MEMORY] or [4] is not
set, the initial settings illustrated above are not set.
Mode
EE
In that case, press the OPTION button to cancel.
Signal
Color bar S video
Measurement Point
TP303
Measuring Instrument
Digital voltmeter
Adjusting Element
CV303
Specified Value
2V£0.2VDC
-165-
Advertisement
Table of Contents
