Turning To The Standby Mode; Automatically - Sony RSE-500 Operating Instructions Manual

os lll Hl
Automatically
You can automatically switch among the pictures (up
to 256 cameras) at regular intervals.
Setting the Time When the
Pictures are Switched
1 select 9. CAMERA AUTO SCAN from the
SETTING menu.
The following screen appears.
—— CAMERA AUTO SCAN——
min: [[0xx 1]
(0123456789 Es
sec: [0x1
0123456789 E
<CANCEL> «OK»
2 Select the minutes using € or »», then press
ENTER one by one.
The selected number is entered in the minutes box.
Press Y and select the seconds using € or », then
press ENTER one by one.
The selected number is entered in the seconds box.
* An asterisk is displayed where nothing is entered.
* If you select O for minutes and seconds, the
pictures are not switched automatically.
3 Move the cursor to «OK» using *. then press
ENTER.
The setting is registered and the SETTING menu
appears.
2-14 (en)
Chapter 2 Setup Using the SETTING Menu
Standby Mode Automatically
You can set the system to disconnect the line
automatically or turn to standby mode automatically to
save power.
Setting the Time When the Unit
Disconnects From the Line or
Turning to the Standby Mode
1 To set the time when the unit disconnects from the
line, select 10. TIME OUT 1 from the SETTING
menu.
To set the time when the unit turns to the standby
mode, select 11. TIME OUT 2 from the SETTING
menu.
The following screen appears. (The illustration
below is for selecting 10. TIME OUT 1.)
—————11ME OUT!
min: [[Dkx1
(0123456789 ES
sec: [0x]
0123456789 85
<CANCEL> «OK»
—————————— aaaaaaaaaaaaaaaaaaamaaaaaasasasasauauaasasasasauatauasasastl
2 Select the minutes using € or ®, then press
ENTER one by one.
The selected number is entered in the minutes box.
Press Y and select the seconds using € or ®, then
press ENTER one by one.
The selected number is entered in the seconds box.
* An asterisks is displayed where nothing is
entered.
* [f you select 0 for minutes and seconds, the unit
does not automatically disconnect from the line or
turn to the standby mode.
3 Move the cursor to «OK» using ¥, then press
ENTER.
The setting is registered and the SETTING menu
appears.
To turn on the power from the standby mode
* Press any key on the Video Transmitter or Remote
Commander.
* Select any location on the tablet (not supplied).