GE Voluson S6 Basic User Manual page 411

11.2.3.3 Before starting Small Parts Calculations
Note
11.2.3.4 Small Parts Calculations in 2D Mode
11.2.3.5 Small Parts Calculations in M Mode
11.2.3.6 Small Parts Calculations in Spectral-Doppler Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
1. Press the [Patient] key on the control panel, select the [SM P] page and enter all patient
information for Small Parts calculations. For details refer to: Entering Patient Data
'Entering Patient Data' on page 4-10 )
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Select [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Small Parts. For details
refer to: Probe/Program Selection
•
Distance Measurements (like Length, Height, etc.)
•
Vessel Area/Vessel Diameter
•
Stenosis Area/Stenosis Diameter
The measurement procedures in 2D Mode are the same than in application "Abdomen".
review: Abdomen Calculations in 2D Mode
•
Vessel Diameter
•
Stenosis Diameter
•
Time
•
HR (Heart Rate)
The measurement procedures in M Mode are the same than in application "Abdomen". review:
Abdomen Calculations in M Mode
•
Auto Trace
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Abdomen Calculations' on page 11-24 ) .
(chapter 'Abdomen Calculations' on page 11-24 ) .
(chapter
11-35