HP 61010A Owner's Manual page 67

A
Programming Statement
Summary
System
Statements
instrument
Statements
The following is a summary of the progamming statements
that can be used to control the Digital. I/O. You can use
this summary as a reference guide for spelling and syntax
of the available statements.
DISABLE.SYSTEM
ENABLE.SYSTEM
INITIALIZE.SYSTEMfsfafe/i/U
Statements Common to Input and Output
CHECK.DONEfte&e/,//^)
DISABLE,H AN DSHAKE(7abeI)
ENABLE.HANDSHAKE(/«fceO
GET.ST AT\)S(label, value)
m\TlAUZE(label,statefile)
SET.LOGIC.SENSE(label,polarity) • where polarity must be
one of the following reserved variables: POSITIVE or
NEGATIVE
SET.NUM.BITSftajbe^friYs) • where bits must be one of the
following reserved variables: Rl, R2, R3, R4, R5, R6, R7,
R8, R9, RIO, Rll, R12, R13, R14, R15, or R16
SET.START.BlTf/a&e^bif) ■ where bit. must be one of the
following reserved variables: RO, Rl, R2, R3, R4, R5, R6,
R7, R8, R9, RIO, Rll, R12, R13, R14, or R15
Statements Specific to Input
MEASURE (label,value)
SET.COM PL EM EHT(label, value) ~ where value must be
one of the following reserved variables: TWOS or
UNSIGNED
SET.THRE$HQLD(label,value)
Programming Statement Summary Ad