Download Print this page

Sharp SM-207H Operation Manual page 26

Stereo amplifier /stereo cassette deck / both sides play stereo turntable
Hide thumbs Also See for SM-207H:

Advertisement

@ Check the POWER switch of the amplifier is in the HLOFF position before carrying out maintenance.
@ The unit requires no lubrication.
Do not oi! it. Lubricating the unit may result in manufunction.
cartridge
ecava
cocoate
tl]
see hase
:
cee
ieee
1 Remove the covers from both sides of the unit.
2 Grasp the stylus or both sides and slide off in the direction
of the arrow.
» GF
Side B cartridge
Side A cartridge
3 Install the new
stylus by reversing the procedure
in 2.
ee
"7
4 Replace the covers.
if dust or dirt is allowed to collect on the stylus, it not only
causes distortion, but also can lead to damage of the stylus or
record.
The stylus should be cleaned in the following manner:
1 Remove the two covers (right and left) on the sides of the
unit.
2 Clean off dust and dirt by brushing in the direction of the
arrow
(see illustration)
with
a supplied
stylus
cleaning
brush,
Do not brush the stylus in the opposite direction, nor from left
to right (when the cartridge faces you), or the stylus may
becomes damaged.
3
Replace the covers.
Though
it varies depending
on
the conditions
under
which
they are used, the average life for the stylus is 500 hours.
Use
of a worn stylus results in sound distortion as well as damage
to
records.
Stylus replacement
should
be done
promptly.
eStylus
assembly STY-144
is available at SHARP
dealers or
service centres,
@Do
not apply undue force to the tonearm
when
replacing
the stylus.
eBe
careful not to drop the stylus into the internal mecha-
nism, as it is then very difficult to retrieve.
@ The cartridge and tonearm are an inseparable unit; commer-
cially available cartridges cannot be used.
The sensor is contained within the cartridge.
If it is allowed to become dirty, it cannot function normally.
e After long periods of use, dust or dirt on the sensor can cause
malfunctions.
1 Remove
the styli as explained
in ''Replacing the Stylus".
2 With
a very soft brush, or photographic-use
blower, etc.,
clean off dust and dirt.
3 Replace styli and the two covers.
tts: onl
N on

Advertisement

loading

This manual is also suitable for:

Rt-207hRp-207h