3) Setting the serial communications parameters
@) Parameter No.
OSetting code
a) When switched to PC set mode, parameter number | is always displayed.
b) Use the shift buttons ( .« and w ) to select the parameter number @) to be changed.
a
: decreases number
w
: increases number
c) Use the +/- buttons to change the setting code © to the required value.
+: increases number
- : decreases number
Note that both + and - buttons cycle round the range of valid numbers.
d)Once parameter number 5 is displayed, pressing w
transmits the settings to the
QA-1150 main unit.
Transmission display
Do not, therefore, press the shift down button ( w ) from parameter number 5 unless the
settings are complete.
4) Operation in PC control mode
Pressing the PC CTL button on the remote control unit switches to PC control mode,
PC control mode indication
32