Troubleshooting; Storage And Disposal - Husqvarna Fleet Services Operator's Manual

Troubleshooting

If the Husqvarna Fleet Services
Husqvarna servicing dealer if you cannot find the cause of the fault.
Symptom
The LED of the Husqvarna
™
Fleet Services Machine Sen-
sor is not on.
The LED of the Husqvarna
™
Fleet Services Machine Sen-
sor flashes 3 times each 3
seconds. The Husqvarna Fleet
™
Services Machine Sensor
does not collect data.
No data is received from the
Husqvarna Fleet Services
Machine Sensor.
"Status unknown" is shown
in the Husqvarna Fleet Serv-
™
ices app or the Husqvarna
Fleet Gateway app.
To reset the Husqvarna Fleet
™
Services Machine Sensor
1. Make sure that the correct product is selected in the
Husqvarna Fleet Services
Fleet Gateway app.
2. Remove the battery and wait 30 seconds before you
install the battery again. Refer to
battery on page 7 .
To put the product in storage
• Put the product in storage in a dry, closed and frost-
free area where the temperature is between 5°C/
41°F and 25°C/77°F.
2132 - 001 - 19.10.2023
Troubleshooting
™
Machine Sensor does not operate as usual, follow the table below. Speak to your
Cause
The light is too low for the light sensor.
The battery is empty.
The data of the Husqvarna Fleet Serv-
™
ices Machine Sensor updates.
The Husqvarna Fleet Services
chine Sensor has not found an electri-
cal field.
The internal clock of Husqvarna Fleet
™
Services Machine Sensor is not set.
The data of the Husqvarna Fleet Serv-
™ ™
ices Machine Sensor updates.
The Husqvarna Fleet Services
chine Sensor is not reset correctly.
™
app or the Husqvarna
To replace the

Storage and disposal

Solution
Put the Husqvarna Fleet Services
chine Sensor in an area that has good
light.
Replace the battery. Refer to
the battery on page 7 .
Wait approximately 15 minutes for the
data to update.
™
Ma- Move the Husqvarna Fleet Services
Machine Sensor near the product until
the light comes on.
Hold the mobile device with the Husqvar-
na Fleet Services
varna Fleet Services
to update the time.
Restart the Husqvarna Fleet Services
app or the Husqvarna Fleet Gateway
app. Wait approximately 15 minutes for
the data to update.
™
Ma- Reset the Husqvarna Fleet Services
Machine Sensor. Refer to
Husqvarna Fleet Services
Sensor on page 9 .
3. Make sure that the Husqvarna Fleet Services
Machine Sensor is connected to the Husqvarna
™
Fleet Services app or the Husqvarna Fleet
Gateway app.
4. Operate the product for a minimum of 30 seconds.
Disposal
• Obey national regulations.
• Use the local recycling system.
™
Ma-
To replace
™
™
app near the Husq-
™
Machine Sensor
™
™
To reset the
™
Machine
™
9