Gcd-Cp10; Figure 3-1 Sv9100 Ethernet Properties - NEC UNIVERGE SV9100 System Maintenance Manual

Hide thumbs Also See for UNIVERGE SV9100:

Table of Contents

Issue 1.0

ECTION

OF THE

Connect to GCD-CP10 Ethernet socket using a crossover cable or via a hub. Set the

IP address of your NIC card within the range of the SV9100 GCD-CP10. The default

IP address of the GCD-CP10 is 192.168.0.10 (Sub Net Mask = 255.255.255.0)

Using a terminal application (e.g. Hyperterminal), set the connection to TCP/Winsock.

The Host IP address is set by Program 10-12-01 on the SV9100. The default is

192.168.0.10 as shown below.

At default the port number is not set and must be programmed in 10-20-06, it can be

any unused network port other than 5963. For the example below port 2000 is used.

You must also enable remote access to the system by setting program 90-31-01 to 1

(Enable). The username is set in program 90-31-02 (Default = SV9100) and the

password is set in program 90-31-03 (Default = 12345678).

3 - 2

N TO THE

GCD-CP10

DIM L

OCALLY VIA THE

UNIVERGE SV9100

THERNET

OCKET

Table of Contents

Table of Contents