Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. 1 609 92A 0M3 | (19.4.17) Bosch Power Tools...
Page 5
Kickback will propel the Anyone entering the work area must wear personal tool in direction opposite to the wheel’s movement at the protective equipment. Fragments of workpiece or of a point of snagging. Bosch Power Tools 1 609 92A 0M3 | (19.4.17)
Page 6
The replacement plug should have the same fuse rating as the original plug. 1 609 92A 0M3 | (19.4.17) Bosch Power Tools...
The severed plug must be disposed of to avoid a possible Technical Data shock hazard and should never be inserted into a mains sock- Angle Grinder PWS 620-100 et elsewhere. Products sold in AUS and NZ only: Use a residual current de- Article number 3 603 D14 0..
Page 8
Screw on the round nut 16 and tighten with the two-pin span- ner. Cup Brush/Disc Brush For operations with the cup brush/wheel brush, always mount the hand guard 13. See graphics page for the mounting sequence. 1 609 92A 0M3 | (19.4.17) Bosch Power Tools...
To start the power tool, press the On/Off switch 2 forward and then down. To lock-on the pressed On/Off switch 2, push the On/Off switch 2 further forward. Bosch Power Tools 1 609 92A 0M3 | (19.4.17)
Tel.: (02) 8999091 If the replacement of the supply cord is necessary, this has to Fax: (02) 8976432 be done by Bosch or an authorized Bosch service agent in or- rosalie.dagdagan@ph.bosch.com der to avoid a safety hazard. 1 609 92A 0M3 | (19.4.17)
Page 11
Tel.: 02 6393111, 02 6393118 environmental-friendly recycling. Fax: 02 2384783 Do not dispose of power tools into household waste! Robert Bosch Ltd., P. O. Box 2054 Bangkok 10501, Thailand Subject to change without notice. www.bosch.co.th Bosch Service – Training Centre La Salle Tower Ground Floor Unit No.2...