Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
(Continued from previous page)
Caution: Do NOT initiate simultaneous menu sessions while a Pro:Idiom key
installation is in progress. Doing so will interfere with the active processes and
may corrupt the system configuration and/or cause the HCS6320 card to cease
normal operation.
1.
Confirm the directory location of the Pro:Idiom key (.hex) file.
the key file must be available on the same machine as the TFTP server.
2. Access the HCS6320 Main Menu as described on page 30.
[Main] Command > prompt, type pi and press Enter.
3. At the
Use TFTP to download key (y/n)? prompt, either:
4. At the
• Type y and press Enter to use TFTP for the Pro:Idiom key installation.
• Type n and press Enter if you will not use TFTP for the Pro:Idiom key installation. At the
next system prompt:
Enter.
5. Refer to the appropriate subsection below, depending on the file transfer option used.
Xmodem File Transfer
The system will request a key file. Transfer the new Pro:Idiom key file using Xmodem
protocol.
For example, in HyperTerminal, select Transfer and then Send File.... In the Send File
window, enter or select the appropriate Pro:Idiom key file in the Filename field, and select
Xmodem in the Protocol field.
TFTP Transfer
The HCS6320 must be connected to an IP network for a TFTP transfer. TFTP transfer also
requires that you set up a TFTP server on the same IP network as the HCS6320. Consult
the network administrator, as necessary, for further information.
a) Make sure the key file is available on the same machine as the TFTP server. Then, set
up the TFTP server, and point to the directory in which the Pro:Idiom key file is located.
Note the name of the Pro:Idiom key file; you will need it to initiate the transfer.
Enter TFTP server IP prompt, type the IP address for the TFTP server
b) At the
and press Enter, or simply press Enter if the default IP address shown in square
brackets is correct.
Enter the PI key file name prompt, type the name of the Pro:Idiom key
c) At the
file in the format "filename.hex" and press Enter.
The system will display progress messages as well as the result of the installation process.
Note that the new key will be stored in non-volatile storage regardless of process results.
34
Use XMODEM to transfer files (y/n)? , type y and press
Get other manuals https://www.bkmanuals.com
Note: For a TFTP file transfer,
206-4183
Advertisement
Table of Contents
