Servicing The Transmission - Toro 25450A Operator's Manual

6. Fill the axles with the specified oil through the sight
port until the oil is level with the threads at the bottom
of the port (Figure 95
7. Wait a few minutes for the oil to settle, then add more
oil as necessary.
Note: Continue to add oil until the oil level stabilizes
and is at the bottom of the threads of the sight port.
8. Install the fill plugs into the sight ports of the pinion
housings for the axles
Cleaning the Axle Breathers
Service Interval: Every 1,000 hours
1. Clean the area around the breathers with a cleaning
solvent (Figure 97
1. Breather fitting
1. Breather fitting
2. Remove the breathers from the front axle and rear
axles (Figure 97 and
3. Clean the breathers with a cleaning solvent.
4. Use compressed air to dry the breathers.
Important: Wear face protection when using
compressed air.
5. Install the breathers into the front and rear
97 and Figure 98).
and Figure 96).
(Figure 95 and Figure
and Figure 98).
Figure 97
2. Front axle
Figure 98
2. Rear axle
Figure 98).
axles(Figure

Servicing the Transmission

Transmission-oil specification: Mobilfluid 424
Checking the Oil Level in the
Transmission
Service Interval: Every 100 hours
Important: If you operate the machine while the level of
96).
the transmission oil is below the recommended level, you
may damage the transmission and the parking brake.
1. Park the machine on a level surface.
2. Start the engine and run it for 10 minutes.
3. Stop the engine and remove the ignition key.
4. After 5 minutes, check the transmission oil level in the
sight gauge
Note: The oil level should cover 1/2 to 3/4 of the
sight-gauge window.
1. Sight gauge
5. If the oil level is low, add the specified oil into the
transmission; refer to
(page
6. Repeat steps
to 3/4 of the sight-gauge window
Note: As you add oil to the transmission, perform
steps
62
(Figure 99).
Figure 99
Filling the Transmission with Oil
63).
2 through 5 until the oil level covers 1/2
2 through 4 to determine the corrected oil level.
(Figure 99).