Select Security Mode - Toshiba GN-1040 Operator's Manual

Select Security Mode

After specifying the SSID, you must select the security mode for your wireless network.
The procedure to configure the security mode varies depending on the security mode
that you select.
NOTE: If you are not sure what security mode to select, see the following section to determine
the security mode.
Selecting 802.1x security mode with EAP-TLS protocol
Using the 802.1x authentication with the EAP-TLS protocol, you must install user certifi-
cation file and CA certification file in the equipment. This equipment uses the user cer-
tification file to authenticate the access rights to the wireless network, and the RADIUS
server authenticate this equipment using the CA certification file.
NOTE: When using the 802.1x authentication with the EAP-TLS protocol, you must install the
CA certification file and user certification file in the equipment using TopAccess first.
For instructions on how to install the CA certification and user certification files using
TopAccess, please see TopAccess Guide.
1.
2.
GN-1040 Operator's Manual — Setting Up the Infrastructure Mode
P.19 "Selecting 802.1x security mode with EAP-TLS protocol"
P.24 "Selecting 802.1x security mode with PEAP protocol"
P.27 "Selecting WPAPSK security mode"
P.29 "Selecting WEP security mode"
P.31 "Selecting no security mode"
P.11 "3. Determine the Security Mode"
Press the [802.1x] button and press the [NEXT] button.
• The 802.1X AUTHENTICATION SETTINGS screen is displayed.
Press the [EAP-TLS] button and press the [NEXT] button.
• The WIRELESS AUTHENTICATION (EAP-TLS) screen is displayed.
1. Setting Up Wireless Network
19