Table of Contents
Advertisement
1
1.1
Follow these safeguards and properly use the equipment to prevent injury and damage to
any equipment/data.
Operating/storage environment
• Do not use or store the equipment near flammable chemicals such as alcohol,
thinner, benzine, etc.
If chemicals are spilled or evaporate, it could result in fire or electric shock through
contact with electric parts inside the equipment. Also, some disinfectants are
flammable. Be sure to take care when using them.
• Do not connect the equipment with anything other than specified.
Doing so could result in fire or electric shock.
• Do not install or store the equipment in any of the locations listed below.
Doing so may result in failure or malfunction, equipment falling, or fire or injury.
– Close to facilities where water is used
– Where it will be exposed to direct sunlight
– Close to the air outlet of an air-conditioner or ventilation equipment
– Close to a heat source such as a heater
– Where the power supply is unstable
– On the floor
– In a dusty environment
– In a saline or sulfurous environment
– Where temperature or humidity is high
– Where there is freezing or condensation
– In areas prone to vibration
– On an incline or in an unstable area
• Be sure that the patient is in continuous contact with the surface of the detector
for less than 1 minute. Depending on the heat generated by the internal device,
the temperature of the detector's surface may increase by up to 9°C. Avoid
prolonged contact with the surface of the detector in order to decrease physical
stress and the possibility of low-temperature burns due to contact with the
patient's skin.
4
Safety information
Safety precautions
Advertisement
Table of Contents
