SWITCHING SELECTION OF FUNCTION SETTING MODE
(2) Press and hold the "MANUAL/AUTO"
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
●
The position of the "MANUAL/AUTO" button varies depending on the model.
Refer to the operation manual for the position that is included with the unit.
●
The error will be displayed by continuously pressing the "MANUAL/AUTO" for 10 sec or more. In this case
release the button or turn off the power.
●
An explanation of the displayed information as shown below.
SELECTION AND CONFIRMATION OF CUSTOM CODE
(4) Press the " SET TEMP.
TEMP.
" buttons to select the custom
q
code that matches the setting with the
indoor unit.By selecting the appropriate
custom code, the communication between
the indoor unit and the wireless RC
become possible.
CUSTOM CODE
( - - - )
The initial setting is " "
(3) Press and hold the "FAN" and the " SET
Pi Pi Pi
MANUAL
AUTO
" or " SET
(5) Press the "TIMER MODE" button to send
p
- (07-96) -
TEMP.
" buttons. Whilst holding these
p
2 buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
the code to the indoor unit.
Correct code:
Wrong code:
No Response
Function setting
mode display
Pi Pi