Download Print this page

Sealey AK450DP Manual

Air powered pump away station

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of waste oil. Dispose of waste oil in accordance with
local authority regulations.
WARNING! Turn off air supply and de-pressurise the output line before removing the pump unit from any installation or mobile system.
Failure to comply with this instruction may damage the unit and will invalidate the warranty.
WARNING! Disconnect the pump from the air supply before changing accessories, servicing or performing any maintenance.
WARNING! Ensure correct air pressure is maintained and not exceeded.
Familiarise yourself with the application and limitations of the product as well as the potential hazards.
9
Install the pump in an appropriate working area. Keep area clean and tidy, free from unrelated materials and ensure there is adequate
9
lighting.
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
When not in use ensure the air supply is turned off.
9
Keep the pump clean for best and safest performance.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
Keep air hose away from heat, oil and sharp edges.
9
Check air hose for wear before each use, and ensure that all connections are secure.
9
DO NOT allow unauthorised persons to operate the pump.
8
DO NOT operate the drainer if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT point airline at yourself, other persons or animals.
8
WARNING! DO NOT tamper with, or open, the pump unit. To do so will invalidate the warranty.
DO NOT use the pump to draw off any other liquids other than oils.
8
DO NOT force the pump to schieve a task it was not designed to perform.
8
DO NOT allow untrained persons to operate the pump
8
DO NOT operate the pump when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT leave the pump operating unattended.
8
2. INTRODUCTION
Air operated 1:1 oil pump, suitable for use with Model No's AK450DX and AK468DX oil drain units. Supplied with a wall mounting bracket, 2m
flexible hose with dry-fit male and female quick couplings to attach it to the drain unit. 2m flexible air supply hose with filter, lubricator and regulator
assembly is also included. The pump can be plumbed into a run of pipework to a waste oil storage point sited out of the workshop.
3. SPECIFICATION
Model no ....................................................................AK450DP
Air consumption ..............................................................8.8cfm
Min/max air pressure ................................................. 30/120psi
Oil delivery @90psi ......................................................60L/min
4. CONTENTS
1. Pump
2. Filter-regulator
3. Lubricator
4. Pressure gauge
5. Mounting bracket, filter-regulator
6. Air inlet hose and fitting
7. Suction hose and fittings
8. Wall bracket, pump
9. Hex plug, regulator
© Jack Sealey Limited
AIR POWERED PUMP AWAY STATION
MODEL NO:
Wear
Wear
protective
protective
clothing
gloves
10. Fitting, air system - 2 off
Original Language Version
AK450DP
fig.1
AK450DP Issue:3 (H,F) 11/6/21

Advertisement

loading

Summary of Contents for Sealey AK450DP

  • Page 1 AK450DP MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 This unit is designed to automatically lubricate the pump via the air supply. The unit must be kept topped up with good quality air tool oil (Sealey reference: ATO/500 - 500ml size or ATO/1000 - 1L size). To adjust the oil flow turn the oil regulator on the top of the unit.
  • Page 3 Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...