Advertisement
INSTALLATION
12
Installation Place
Requirements
Before installing the appliance, check the following
information to make sure that the appliance
should be installed in a correct place.
Dimensions
A
B
C
D
E
F
Installation Location
• A grounded electrical outlet should be located
within 61 cm of either side of the appliance.
• Install the appliance on a flat floor. (Allowable
slope under the appliance: 1°)
• The floor must be level, with a maximum slope of
2.5 cm under the appliance. If the slope is
greater than 2.5 cm, the appliance cannot be
levelled properly.
Dimensions (mm)
520
1500
460
1960
600
605
• Ensure that when the appliance is installed, it is
easily accessible for an engineer in the event of a
breakdown.
• Do not install the appliance in any outdoor area,
or any area that is subject to weathering
conditions such as direct sunlight, wind, rain, or
temperatures below freezing. Failure to follow
this warning could result in risk of electric shock,
injury, or product damage or malfunction.
• Do not install the appliance on a hollow or
flexible platform, or any elevated surface, plinth
or stand. Doing so may cause excessive noise
and vibration and result in damage or injury if
the appliance tips over.
NOTE
• A sturdy floor or solid floor should support the
total appliance weight of 100 kg. The combined
weight of any other laundry appliances should
also be considered.
Recommended Installation
Spacing
The following clearances are recommended for the
appliance. Although the appliance has been tested
for clearances of 3 cm on the sides and rear,
recommended clearances should be considered
for the following reasons:
Allow at least 46 cm in front to open the door.
a
b
Allow at least 5 cm on both sides and between
the back of the appliance and the wall.
Advertisement
