Husqvarna 435 Operator's Manual page 24

To do a check of the right hand guard
• Make sure that the right hand guard is not damaged
and that there are no defects, such as cracks.
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Press the start/stop switch down to the STOP
position. The engine must stop.
To do a check of the muffler
WARNING:
arrester and spark arrester mounting
face may contain deposits of combustion
particles on the surfaces that may be
carcinogenic. To avoid skin contact and
inhalation of such particles when cleaning
and/or servicing the spark arrester, make
sure you always:
• wear gloves;
• clean and/or service in a well ventilated
area;
• do not use pressurized air to clean the
spark arrester screen;
• use a steel brush and brush away from
your body when cleaning the spark
arrester.
WARNING:
the spark arrester mesh on the muffler is
missing or defective.
24
A used muffler/spark
Do not use a product if
1. Examine the muffler for damages and defects.
WARNING:
that has a defective muffler or a muffler
that is in bad condition. Return product
to a Husqvarna dealer/service station if
the muffler is defective.
2. Make sure that the muffler is correctly attached to
the product.
Note:
Do not remove the muffler from the product.
3. If your product has a special spark arrester mesh,
clean the spark arrester mesh weekly.
4. Replace a damaged spark arrester mesh.
CAUTION:
is blocked the product becomes too hot
and this causes damage to the cylinder and
piston.
Do not use a product
If the spark arrester mesh
1270 - 007 - 06.12.2022