Mitsubishi Electric MR-E A Series Instruction Manual page 249

15. MR-E-
15.1.4 Model code definition
MR - E -
Series
Rated output
Symbol Rated output [W] Symbol Rated output [W]
10
20
40
www.DataSheet4U.com
15.1.5 Parts identification
(1) MR-E-100AG or less
MODE
MITSUBISHI
MR-
CN2
CNP2
CNP1
AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
AG
Analog input
100
70
200
100
400
200
SET
CN3
CN1
MR-E-40AG or less
750
1000
2000
Rating plate Rating plate
Name/Application
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
MODE UP DOWN
Communication connector (CN3)
Used to connect a command device (RS-232C)
and output analog monitor data.
I/O signal connector (CN1)
Used to connect digital I/O signals.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Motor power supply connector (CNP2)
Used to connect the servo motor.
Power supply/regenerative connector (CNP1)
Used to connect the input power supply and
regenerative brake option.
Protective earth (PE) terminal (
Ground terminal.
15 - 4
MR-E-70AG, 100AG MR-E-200AG
SET
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
Section13.1.2
Section13.1.2
Section13.1.1
)
Rating plate
Refer to
Chapter6
Chapter6
Section3.3
Chapter14
Section3.3
Section3.3
Section3.7
Section11.1
Section3.7
Section11.1
Section3.10
Section11.1