Transport And Storage; Transporting The Axial Piston Unit; Transporting By Hand; Transporting With A Lifting Device - Bosch Rexroth A10VO Instruction Manual

Dimensions and weights
Transporting with
eye bolt

6 Transport and storage

▶ Always observe the necessary ambient conditions for transport and storage,
see chapter 6.2 "Storing the axial piston unit" on page 23.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page 25.

6.1 Transporting the axial piston unit

The following transportation options are available depending on weight and duration
of transport:

• Transporting by hand

• Transporting with a lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size
A10VO without through drive
A10VO with through drive
A10VSO
A10VNO without through drive kg
A10VNO with through drive
A10VSNO
Width
Height
Depth
Weight may vary by equipment.
6.1.1 Transporting by hand
Axial piston units with a weight of up to 15 kg can be transported by hand for a short
time, if necessary.
CAUTION! Danger from heavy loads!
Health hazard from carrying axial piston units.
▶ Use appropriate lifting, lowering and moving techniques.
▶ Wear your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Do not transport the axial piston unit by sensitive assembled parts
(e.g. sensors or valves).
▶ Carefully place the axial piston unit on the seating to prevent it from being
damaged.
6.1.2

Transporting with a lifting device

For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶ For all female threads, use a stud end from the same system of units and of the
correct size.
RE 92703-01-B/04.2018, A10VO, A10VSO, A10VNO, A10VSNO Series 52 and 53, Bosch Rexroth AG
10 15 18 28
kg – – 11.5 15
kg – – 13 18
kg 8 – – –
– – – 11.5
kg – – – 13
kg – 8 – –
mm Dimensions vary by equipment. The values applicable
for your axial piston unit can be found in the installation
mm
drawing (request if necessary).
mm
Transport and storage
45 60 63 72 85
18 22 22 22 36
24 28 28 28 45
– – – – –
15 – 18 – 22
18 – 24 – 28
– – – – –
21/60
100
36
45
–
–
–
–