Table of Contents
Advertisement
5
Adjustment > Adjustment at Time of Parts Replacement > Adjustment After Replacing Finisher Controller PCB
20)
Correct the position of the stopper fixture according to the displacement amount (C)
for folding position that was measured in step 1).
Procedure: Turn the cross-hole screw [1] to adjust the position of the lead edge stopper
fixture [2] upward/downward.
(0.5mm-change per turn)
21)
After the adjustment is completed, tighten the fixing screw of the lead edge stopper.
22)
Output the paper from the saddle assembly and check the result.
5
Adjustment > Adjustment at Time of Parts Replacement > Adjustment After Replacing Finisher Controller PCB
[2]
[1]
F-5-124
Adjustment After Replacing Finisher Controller PCB
Execute this adjustment when replacing the finisher controller PCB.
1) Execute the following adjustments:
• Adjusting Sensor Light Intensity
• Adjusting the Alignment Position of the Upper Neat Alignment Plate
• Adjusting the Alignment Position of the Lower Neat Alignment Plate
• Adjusting the Height of Corrugation Roller for Stack Delivery
• Adjusting Alignment Plate Position
• Adjusting Staple Position (1-stapling at the rear)
• Adjusting Staple Position (1-stapling at the front)
• Adjusting Staple Position (2-stapling positions)
• Adjusting Delivery of Staple Stack (lower delivery)
• Adjusting Delivery of Staple Stack (saddle delivery)
• Adjusting Delivery of Staple Stack (lower delivery)
• Adjusting Delivery of Staple Stack (saddle delivery)
• Adjusting Position of Saddle Lead Edge Stopper
• Adjusting Saddle Stitching Position
• Adjusting Saddle Folding Position
• Bufferless Mode
• Adjustment in the Case of Failure in Stacking Performance of Tray (upper curl)
• Adjustment in the Case of Failure in Stacking Performance of Tray (lower curl)
• Adjustment in the Case of Failure in Stacking Performance of Tray (run-on of paper
when using thin paper)
• Adjustment in the Case of Canceling Limit for Tray Stack
5-52
5-52
Advertisement
Table of Contents
