Contents For your safety This equipment has been designed and For your safety ......... 1 manufactured to meet international safety stan- dards but, like any electrical equipment, care Important Information ......4 must be taken if you are to obtain the best Remote Control Buttons ......
Page 3
DO DONT continue to operate the equipment if you are in any doubt about it working normally, DO read the operating instructions before you or it is damaged in any way switch off, with- attempt to use the equipment. draw the mains plug and consult your dealer.
Page 4
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING Do not allow children to hang from the TV, place their elbows on the TV or lean against the TV. Doing so may cause the TV to fall over and lead to injuries.
Important Information Please take note EXCLUSION CLAUSE JVC shall under no circumstances be liable for loss and/or damage to the product caused fire; earthquake; accidental damage; intentional misuse of the product; use of the product in improper conditions;...
Remote Control Buttons / I = (Stand By) button TV / VCR / DVD Switch Number buttons & AV button (EXT-1, EXT-2, EXT-2S, EXT-3, EXT-4, EXT-4S, BLUE / PICTURE Mode button YELLOW / Sleep Timer button MENU button ,&785( = Cursor Up button OK button = Cursor Right button BACK button...
Control Panel Buttons and Terminals 7$1'%< 352*5$00( 83'2:1 92/80( 83'2:1 0(18 79$92. +($'3+21( 63($.(5 ,1)5$5(' 63($.(5 32:(5 5(&(,9(5 /$03 With certain combinations of connectors and leads the back cover may not be easily fitted. If the cover is left off, this in no way infringes safety requirements.
How to remove the stand Loosen the 5 screws that attach the stand to the TV. Gently pull the stand downwards to remove it. ENGLISH - 8 - Downloaded from: https://www.usersmanualguide.com/...
Installing TV on the wall WARNING When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is designed for this TV. Make sure that the TV is installed on the wall by a skilled installer.
When no valid signal is detected, after 5 min- Preparation utes the TV switches itself automatically to Install Display on solid horizontal surface such stand-by mode. as a table or desk. NTSC Playback. For ventilation, leave a space of at least 10 cm ...
Inserting batteries in the remote Switching the TV ON/OFF control handset To switch the TV on Remove the battery cover located on the back Your TV will switch on in two steps: of the handset by gently pulling downwards 1- Connect the power cord to the system.
To use T-V Link functions APS, searches and sorts all channels and A T-V Link compatible VCR means a JVC stores them automatically on your TV, accord- video cassette recorder with the T-V Link logo, ing to the transmission of programme sys- or with one of the following logos.
If FEATURE NOT AVAILABLE is displayed, Operating the TV download was not performed correctly. Before You can operate your TV using both the re- trying to download again, check that: mote control handset and onset buttons. The VCR power is turned on. Volume setting and programme selection can ...
Menu System Your TV has been designed with a menu sys- tem to provide an easy manipulation of a multi- function system. The TV is controlled by choos- ing the commands, which are displayed on the screen. Programme Selection (Previous or next MAIN MENU programme) Press the MENU...
Page 16
vp r vp r Hqr 7 vtu Hqr 7 vtu 8 h 8 h Ã7 vtu Ã7 vtu ÃTuh r ÃTuh r 8y 8y 8y ÃUr 8y 8y ÃUr 8y IvrÃSrqÃÃÃÃÃÃÃÃÃÃÃÃ IvrÃSrqÃÃÃÃÃÃÃÃÃÃÃÃ Ã)ÃS@T@U Ã)ÃS@T@U Setting Colour Setting Contrast Using or button select Colour. Using or ...
Page 17
Setting Hue Setting Treble Level During Playback NTSC system, this will ap- Using or button select Treble. pear in AV mode only when NTSC video source Press button to increase treble level. is applied.
Page 18
When Off is selected, there will be no differ- Press button to increase volume. ence in the operation of your TV. When On is Press button to decrease volume. selected, the TV can only be controlled by the remote control handset.
Page 19
In EXT mode, Install menu appears like this: Decoder(EXT-2) You can use this mode to connect any de- coder to your TV. Press the or buttons to set it On or You can change only Colour system and Off.
Page 20
each character of channel name. 4. Press the RED button to store the channel name. To cancel the Name mode, press the BLUE button. To delete a channel (Delete): 1. Choose the channel you want to delete. 2. Press the YELLOW button to enter the De- lete mode.
Source Menu Other Features You can switch your TV to EXT modes by TV Status pressing directly to AV button or by selecting Programme Number, Programme Name (or in source menu from the main menu. EXT), (they are displayed on the upper left of While in EXT mode, you can also switch your the screen).
Page 22
After a Remote Control command (if No-Sig- nal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down. It is not valid in EXT modes. No-Signal and Out Of Range Detection (PC mode) In PC Mode, as no menu is displayed, in case...
Page 23
Zoom Modes Zoom mode can be changed by pressing the Red button. You can change the screen size according to the picture aspect ratio. Select PANORAMIC: the optimum one from the following ZOOM modes. This stretches the left and right sides of a nor- mal picture (4:3 aspect ratio) to fill the screen, AUTO: without making the picture appear unnatural.
Auto Position PC Mode If you shift the picture horizontally or vertically Installation to an unwanted position, use this item to put the picture into correct place automatically. Power off both Computer and Display before making any connections. Select Auto position item by using ...
Page 25
PC Picture Menu PIP size is changed by button. Two dif- ferent PIP sizes are available. In the Main menu, select PC Picture using or button, then enter the PC Picture Programme in the PIP window is increased / decreased by ...
buttons. The page will be searched and the Teletext page number will be displayed on the upper Teletext is an information system that displays left corner of the screen when the selected text on your TV screen. Using the Teletext in- page is found.
selected page is found. Peripheral Equipment Press button to display the selected Connections Teletext page. There is a wide range of audio and video equip- To exit Teletext ment that can be connected to your TV. Connection diagrams at the end of this sec- ...
Page 28
If you have a device which outputs component NTSC Playback signal, connect it to the EXT-3 terminal with a Connect a NTSC video recorder to a terminal. component video cable. Then press AV button to select the corre- Via the ANT (aerial) socket sponding AV mode.
PC Input Typical Display Modes The display has a maximum resolution of 1360 x 768, vertical sync. frequency range of 50-75 Hz and a horizontal sync. frequency range of 30-69 KHz. The following table is an illustration of some of the typical video display modes. 5 HV R OX WLR Q ) U HT X HQ F\ 0 R G H...
PC Picture Tips If no PC picture appears, check that the D- Can not turn the TV on? SUB cable is connected properly. Check that Check that TV/VCR/DVD switch is set to TV your PCs resolution set correctly. See page position.
Specifications Model Item LT-26B60BU LT-26B60SU Broadcasting Systems PAL SECAM BG, DK, I, L, Lp Channels and VHF (VL) 46,25 MHz - 168,25 MHz Frequencies VHF (VH) 175,25 MHz - 463,25 MHz 471,25 MHz - 863,25 MHz Cable TV (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
Page 33
This file has been downloaded from: www.UsersManualGuide.com User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes.. Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide, manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product, documentation manual, user maintenance, brochure, user reference, pdf manual Downloaded from:...