CONTROL FUNCTION
SKID
1
1. Skid
2. Auger end
3. Road surface
4. Clearance
The skid is used to determine a clearance
between the auger end and the road sur-
face. Adjust the clearance according to
road surface conditions (see page 50).
NOTICE
If the clearance between the road sur-
face and the auger end is too small,
auger wear may increase and the road
surface could be damaged.
Factory set
(Standard position)
Concrete and asphalt
roads
Pebble and gravel
roads
2
4
3
Clearance between
the auger end and
the road surface
5 mm (0.197 in)
Decrease
Increase
SCRAPER
1. Scraper
The scraper is used to flatten the surface to
plow snow. Adjust the clearance between
the road surface and the scraper end ac-
cording to road surface conditions (see
page 54).
Factory set
(Standard position)
Concrete and asphalt
roads
Pebble and gravel
roads
– 20 –
1
Clearance between
the road surface and
the scraper end
5 mm (0.197 in)
or more
Decrease
Increase