Brick Settings - Sony DVS-9000 User Manual

3
4

Brick Settings

This effect creates a rectangular parallelepiped from 3 successive channels.
For an illustration, see "Global Effects" in Chapter 1 (Volume 1).
Applying the Brick effect
1
2
3
136
Global Effect Operations
Press [Combiner2 Depth], turning it on.
Set the following parameter.
Knob Parameter Adjustment
1 Soft2 Softness of edges of channel 3
and channel 4 crossed section
In the Global Effect >Ch1 - Ch4 menu, select HF2 'Brick.'
The Brick menu appears.
Press [Brick], turning it on.
The Brick effect is enabled, and a rectangular parallelepiped (brick)
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
Notes
• When the Brick effect is enabled, the z-axis position of the front image
in the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
• The flex shadow function cannot be enabled when Brick is enabled.
However, the flex shadow function is not supported on the MVE-8000A.
Set the parameters.
Knob Parameter
1 Height
2 Front Overlap
3 Side H Overlap
4 Side V Overlap
Setting values
0.00 to 100.00
Adjustment Setting values
Height of brick 0.00 to 8.00
Front overlap –100.00 to +100.00
Side H overlap –100.00 to +100.00
Side V overlap –100.00 to +100.00