FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-36 Fingerprint and card lock
Step 3 Install a new fingerprint and card lock and connect the monitoring cable to the
lock.
Step 4 Log in to the ECC800-Pro WebUI, choose System Settings > Access Management,
set the access permissions for the new fingerprint card lock according to those of
the damaged fingerprint card lock. Then click Synchronize to Device to
synchronize the permissions.
Step 5 On the ECC800-Pro WebUI, choose System Settings > Device Management >
Device Deletion and select a device type from the Select a device type drop-
down list. Select a desired device in the Devices list, click Delete, and add the new
device to the smart module view.
Step 6 Check that the fingerprint and card lock functions properly.
----End
5.4.3.9 Replacing an Automatic Door Status Sensor
Impact on the System
The automatic door status sensor cannot be used to control the door.
Preparations
●
Procedure
Step 1 Disconnect the cable from the automatic door status sensor to the actuator.
Step 2 Remove the automatic door status sensor.
Issue 02 (2022-07-30)
Material: automatic door status sensor
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Parts Replacement
89