FINAL DRIVE
FRONT HUB / BEARING
HUB REMOVAL / INSPECTION
1. Elevate and safely support front end of the machine
under the footrest / frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping the tire /
wheel firmly and checking for movement. Grasp the
top and bottom of the tire. The tire should rotate
smoothly without binding or rough spots.
3. Remove wheel nuts, washers, and wheel.
4. Remove the two brake caliper mounting bolts.
CAUTION
q
Do not hang the caliper
hang the caliper to prevent possible damage to the
brake line.
5. Remove hub cap, cotter pin
and washer.
7.4
by the brake line. Use wire to
e
, front spindle nut
6. Rotate each bearing
smooth
rotation.
moisture, dirt, or corrosion. Replace bearing if
moisture, dirt, corrosion, or roughness is evident.
HUBSTRUT BEARING REPLACEMENT
Bearing Removal
1. Remove outer snap ring
2. From the back side, tap on the outer bearing race
with a drift punch in the reliefs as shown in Step 3.
w
,
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
r
by hand and check for
Visually
inspect
bearing
q
.
© Copyright Polaris Industries Inc.
for