Table of Contents
Advertisement
Removing the Fender
Remove the 3 self-tapping screws securing the left front
fender to the machine frame
fender.
Note: A step will be installed in place of the fender after the
deck is installed.
1. Self-tapping screws
(Figure
7), and remove the
Figure 7
2. Left front fender
Assembling the Deck Lift Manifold
Block
1. Raise the seat plate.
2. Install the orifice into the deck lift valve manifold as
follows:
CAUTION
If you perform maintenance on the deck lift
manifold while the deck is raised, the pressure
of the hydraulic system could cause serious
injury.
Lower the deck to relieve the pressure in the
hydraulic system.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
g025289
within a few hours by a doctor familiar with
this form of injury or gangrene may result.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
Note: Have a drain pan or a rag available to catch the
hydraulic fluid.
A. Remove the nut securing the spacer/coil assembly
to the solenoid valve in port "A" on the lift
valve manifold block
spacer/coil assembly.
B. Remove the solenoid valve from the lift valve
manifold block
1. Lift valve manifold block
2. Orifice
3. Coil
6
(Figure
8), and remove the
(Figure
8)
Figure 8
4. Solenoid valve
5. Spacer
6. Nut
g025290
Advertisement
Table of Contents
