Versamax Profinet Scanner Controls And Indicators; Versamax Profinet Scanner Leds - GE VersaMax GFK-2721A Manual

VersaMax PROFINET Scanner Controls and Indicators

The illustration below shows a VersaMax PROFINET Scanner with one power supply installed.
Module LEDs
Maintenance LED and
pushbutton
Micro-USB Port and USB
Communications LED
Protective door covers USB port and
Maintenance Mode pushbutton when closed

VersaMax PROFINET Scanner LEDs

Power Supply LEDs
Each Power Supply LED (PWR1 and PWR2) is ON solid green when a minimum level of power
is being supplied on the corresponding power supply connector on the front panel of the
PROFINET Scanner.
OK LED
The OK LED is solid green ON for normal operation and when the PNS is in Maintenance
Mode. The OK LED flashes or is OFF for all other module states. If there is a failure during
power-up, or a fatal error during normal operation and the scanner is not configured for
automatic restart, the OK LED blinks amber in a failure pattern specific to the error.
GFK-2721A
PNS001
PWR1 (L)
PWR2 (R)
OK
FAULT
CONNECT
LAN
PORT 1 (L)
PORT 2 (R)
MAINT
COMM
!
Chapter 1 Introduction
1
1-5