Table of Contents
Advertisement
Water Hardness Table
ppm
°d
0
<4
75
4 - 7
125
7 - 14
250
14 - 21
375
>21
Setting the Water Softening System
For improved wash performance, adjust the water
softening level based on how hard your water
is.The water softener has 5 settings. The default
setting is H2. Follow these steps to check the
setting and adjust it if needed.
1
Press Power and Half Load button
simultaneously.
• Current setting value indicated.
2
Press the Delay Start button repeatedly to set
the desired softener level from H0 to H4.
3
Press the Start button to save the setting.
• The power turns off after saving.
NOTE
• The Salt Refill
n
icon turns on in the display if
dishwasher salt needs to be refilled.
• Setting the softener level to H0 prevents the Salt
Refill
icon from turning on even when the
n
dishwasher salt container is empty.
Filling the Dishwasher Salt
Fill the dishwasher salt container before starting a
wash cycle. If more salt is needed, the Salt Refill
n
icon will light up on the display, unless the
softener level is set to H0.
CAUTION
• After filling the dishwasher salt container, run
the Rinse cycle immediately to remove any salt
Water Hardness
°e
°f
<5
<7
5 - 9
7 - 13
9 - 17.5
13 - 25
17.5 - 26
25 - 38
>26
>38
mmol/l
mg/l
(Ca+Mg)
(Ca)
<0.7
<29
0.7 - 1.3
29 - 50
1.3 - 2.5
50 - 100
2.5 - 3.8
100 - 150
>3.8
>150
residue from the inner tub and prevent
corrosion.
1
Remove the lower rack and remove the cap of
the salt container located on the left side of
the filters.
2
If you plan to use the water softening system,
you must prime it before using the appliance
for the first time. To do this, mix 2.2 lb (1 kg) of
dishwasher salt with 34 oz (1 liter) of water.
Use the funnel provided to pour the mixture
into the dishwasher salt container. For details
on setting the softener level, see the Before
Using section.
3
Tightly close the cover on the dishwasher salt
container.
4
Run the Rinse cycle without dishes.
Salt Refill Frequency
H1
Cycles
200
• The frequency in the table is based on using the
Auto cycle.
• Different cycles may use different amounts of
salt.
OPERATION
Softening
level
Range
Soft
H0
H1
H2
H3
Hard
H4
H2
H3
H4
60
30
10
23
Advertisement
Table of Contents
