Reference
Further information on wiring the inputs and outputs can be found in the manuals for the
I/O modules.
6.8.4
Bringing the front connector into final position
Bring the front connector from the pre-wiring position into final position
Proceed as follows to bring the front connector from the pre-wiring position into final position:
1. Grip the front connector by the unlocking strap.
2. Pull on the strap until the front connector is released from its latched position.
3. Tilt the top section of the front connector and raise it slightly. The front connector slides
4. Push the front connector back into the I/O module until it latches. The front connector is
5. Swivel the front cover down into place. Depending on the space requirement of the cable
S7-1500 Automation System
System Manual, 02/2014, A5E03461182-AB
over the guide channel into its final position.
Figure 6-14
Bring the front connector from the pre-wiring position into final position
now electrically connected with the I/O module.
harness, various latch positions are possible so that the required cable storage space can
grow as needed.
6.8 Front connector for the I/O modules
Wiring
81