Table of Contents
Advertisement
Modifying Settings
Menu Operations
You can access the setup menu at any time to change or
adjust the unit's various settings. Press the MENU button
on the head mounted monitor to access the setup menu.
Notes
• Settings that are changed in the menu are stored
separately for each HMM output connector on the
image processor unit.
• If you connect the head mounted monitor to the other
HMM output connector on the same image processor
unit, its settings will not carry over.
• If you connect the head mounted monitor to a different
image processor unit, its settings will not carry over.
Menus
The underlined values are the factory defaults.
Lens span adjustment
Back
Lens span adjustment
3D Settings
Back
Reset
3D Display
28
Modifying Settings
Returns to the previous menu.
Adjusts the lens span of the head mounted monitor to match the distance between your
eyes (interpupillary distance) for optimal viewing. Use the lens span adjusters on the head
mounted monitor to adjust the lens span. For details, see "Configuring Initial Settings"
(page 26).
Note
Proper operation is not possible without correct lens span adjustment. Always adjust the
lens span before use.
Returns to the previous menu.
Resets all items under [3D Settings] to their factory default values.
Used to perform adjustments for the unit, etc.
Do not change this setting under normal circumstances.
If you accidentally change this setting, execute the above [Reset] setting.
1
Press the MENU button on the head mounted
monitor.
2
Use the v/V buttons to select a setting category, and
then press the MENU button.
3
Use the v/V buttons to select a setting menu, and
then press the MENU button.
4
Use the v/V/b/B buttons to change or adjust the
setting, and then press the MENU button.
Tips
• To return to a previous menu, press the b button.
• To exit the setup menu, press the b button in the setting
category selection menu.
Advertisement
Table of Contents
