Huawei EchoLife ET325 Manual page 50

Manual do Usuário - EchoLife
ET325 IP Phone
Campo Descrição
Distinctive Custom ring tone 1–3.
Ring Tone
Caller ID: When a ring tone is selected, if a caller ID is
configured, then the device will play only this ring tone
when the incoming call is the number of the set caller ID.
The device will use the system ring tone for all other
calls. When a ring tone is selected but no caller ID is
configured, the selected ring tone will be used for all
incoming calls.
System Ring System ring tone: adopt the North American standard by
Tone default.
The user can adjust the system ring tone's frequencies
and cadences based on their country's telecom standard.
Call Progress These settings can be configured through various call
Tones progress tone frequencies and cadences according to
the standard of country where the phone is located.
By default, call progress tones are set to North American
standard.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
frequencies are in Hz and cadence on and off are in
10ms.
Frequencies should be configured with known values to
avoid uncomfortable high pitch sounds. ON is the period
of ringing ("On time" in ms) while OFF is the period of
silence. In order to set a continuous ring, OFF should set
to zero. Otherwise it will ring ON ms and a pause of OFF
ms and then repeat the pattern. Up to three cadences
are supported.
The default value is No. When two phones establish a
Disable Call
Waiting conversation, the call waiting of a third party will be
disabled.
Disable Call The default value is No. If it is set to Yes, the call waiting
Waiting Tone tone will not be played to remind user when there is an
incoming call, and only a "RINGING" displays on the LED
as the reminder.
4 Guia de Configuração
45