Mounting the IPC on a Panel Using a Backplate
You will need the following:
1. Install the IPC on the Backplate. (See step 1 on page 14.)
2. Drill four holes in the panel based on screw selection using the spacing shown in the following
Drilling Pattern for Panel Mounting Using a Backplate
3. Using the four mounting screws, attach the IPC/Backplate assembly to the panel.
18
Four machine screws with maximum thread size ¼-20 (standard) or M6 (metric)
Driver for selected machine screws
One ICRXIACCBPL Backplate
drawing (if holes are tapped recommended minimum panel thickness should be equal to
thread diameter).
208.3mm
Hardware Installation
(8.2")
PACSystems* RXi Box IPC
119.4mm
(4.7")
GFK-2785C