System Ccu Info - Panasonic AK-HRP1010G Operating Instructions Manual

SYSTEM CCU INFO

The setting values will vary also depending on the connected camera.
Items with the function disabled are indicated by "-".
For details on each setting item, check also the operating instructions of the camera and CCU to be connected.
Item
FORMAT MODE(push) Selects the CCU format mode.
FORMAT Selects the format that is output from the CCU.
The CCU specifies the format to the camera based on the format selected here.
CAMERA NUM Changes the camera number controlled by the CCU.
D/C MODE Selects the down-conversion system for video output from SD SDI and VBS.
U/C MODE Selects the video up-conversion system used for SD SDI and VBS return videos.
RETURN FS Set the delay mode for the HD return signals.
RETURN1 SELECT Sets the input allocations of return signal 1.
RETURN2 SELECT Sets the input allocations of return signal 2.
RETURN3 SELECT Sets the input allocations of return signal 3.
RETURN4 SELECT Sets the input allocations of return signal 4.
BARS HD Specifies the HD color bar output by the CCU.
BARS SD Specifies the SD color bar output by the CCU.
C/B SETUP Set the SD signal output for use with color bar output.
SDI8 OUT Performs PM/NORMAL switching for SDI8 OUT.
HD H COARSE Make the coarse setting of the H_FINE phase used with GL HD REF.
C 0 1 : A K - U C 4 0 0 0
S Y S T E M C C U I N F O
FORMAT MODE(push)
UHD(59.94)
FORMAT
2160/59.94p
CAMERA D/C
NUM MODE
1 SC
C 0 1 : A K - U C 4 0 0 0
S Y S T E M C C U I N F O
RETURN1 RETURN2
SELECT SELECT
RET1 RET2
BARS BARS
HD SD
SMPTE SMPTE
HD H HD H
COARSE FINE
0
C 0 1 : A K - U C 4 0 0 0
S Y S T E M C C U I N F O
SD-HD
V SCH
0H
The "SETUP7.5%" setting is not valid when "SD_SDI" is selected.
1 / 3
U/C RETURN
MODE FS
SC OFF
2 / 3
RETURN3 RETURN4
SELECT SELECT
RET3 RET4
C/B SDI8
SETUP OUT
COMPST PM
SD H SD H
COARSE FINE
0 0 0
3 / 3
CABLE
CONNECT
0 HYBLID
Setting details
- 104 -
ROP menu