Connecting Power Supply; Using The Security Bar And Slot - Hitachi CP-X201 User Manual – Operating Manual

Connecting power supply

At first, make sure that the power switch of the
projector is set to OFF position (marked "O").
1.
Put the connector of the power cord into the
AC inlet of the projector.
2.
Firmly plug the power cord's plug into the
outlet.
WARNING
incorrect or faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Never modify the power cord.

Using the security bar and slot

A commercial anti-theft chain or wire up to
10 mm in diameter can be attached to the
security bar on the projector.
Also this product has the security slot for the
Kensington lock.
For details, see the manual of the security
tool.
WARNING
from falling down, since it is not designed for it.
CAUTION
may become too hot.
NOTE
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
►Please use extra caution when connecting the power cord, as
Anti-theft chain or wire
►Do not use the security bar and slot to prevent the projector
►Do not place anti-theft chain or wire near the exhaust vents. It
AC inlet
Security slot
Security bar
Setting up
Power cord