Product Features; Installation - Electrolux PA21G Instruction Manual

3. Product Features

Filtering System
This appliance purifies water at up to 3 stages,
ensuring 100% treated water.
1. Stage 1: Activated Carbon Filter
Absorbs and removes color, odors, chlorine,
oil, and dissolved gases in large quantities.
2. Stage 2: UF Ultrafiltration
Removes sediments like clay, sand, rust, al-
gae, fungus and iron and other metals sus-
pended particles, salt, etc.
3. Stage 3: Ultraviolet Chamber (for PA31G
only)
The ultraviolet rays generated by the lamp
have a high power with a short wavelength
and are invisible to naked eyes. UV rays
affect bacteria or microorganisms, leaving
them inert and neutralizing them, which re-
sults in safe and completely purified water
before consumption. The UV lamp is housed
in a highly polished stainless steel tube to
ensure good reflection of rays and multiple
exposure of bacteria in a short time, increas-
ing efficiency even when there is a group of
bacteria.
The appliance produces a characteristic op-
erating noise, i.e. the fan will always remain in
operation. When it is identified that the water is
cold, the rotation of the fan should be reduced
but will never be switched off completely.
Dust accumulation in the product can cause the
impression of a higher operating noise. There-
fore it is suggested to clean the air filter as
described on Page 9.

4. Installation

For your peace of mind, Electrolux has a highly
qualified authorized service network to install
the appliance. Call the Customer Service at
3004 8778 (for capitals and metropolitan re-
gions) or 0800 728 8778 (for other regions). An
installation fee may be charged for this service.
Such installation does not include site prepara-
tion service or the materials for the installation
(e.g. masonry, electrical network, power outlet,
circuit breaker, grounding, hydraulic network)
as these would be the responsibility of the
consumer.
4
ATTENTION
Before you begin the installation, please
read all the information below careful-
ly. The information is useful in executing
the installation and ensuring that the ap-
pliance is installed correctly and safely.
Store this manual in a handy place for fu-
ture reference.
Installation site
Do not install the appliance in a place where it is
exposed to direct sunlight or near heat sources
such as a stove and oven.
This product must be installed in a place where
it is easy to access for cleaning and mainte-
nance. During installation, it is essential to en-
sure that the product is kept level, as tilting may
result in leakage.
Make sure the site is strong enough to support
the weight of the product filled with water (ap-
proximately 10 kg).
It is very important to keep the following mini-
mum distances when installing the appliance on
a bench or niche.
Position
Left side
Right side
Rear
Top
ATTENTION
This appliance shall not be installed in a
closed location.
Electrical Installation
The power cord plug of this domestic appliance
complies with the new standard established by
NBR 14136 of the Brazilian Association of Tech-
nical Standards (BATS), and by Ordinance No.
02/2007 of Conmetro.
Therefore, in case your residence is still using
the old standard, we recommend that you ask
a qualified electrician to replace and adapt it to
the new NBR14136 standard.
The benefits of the new power plug standard
are:
• Increased safety against the risk of electric
shock when inserting the plug in the outlet;
Minimum distance
3 cm
3 cm
2 cm
22 cm