Advertisement
Position
Use
3
To remove objects that are blocked in the
drum cutter. The drum cutter rotates in the
opposite direction at half speed.
4
To adjust the flow to the drum cutter.
5
To open or close the concrete crusher, the
steel shears or the grapple.
Note:
Different cutters use different top
buttons to open or close the cutters.
To operate the joysticks with "Extra function"
in operation
1. Press the menu button on the remote control.
2. Select "Custom tool 1-3" in the "Tools" menu on the
display.
3. Select "Extra function 1" or "Extra function 2". Refer
"Custom tool 1–3" on page 37 .
to
4. Push the operation mode switch (A) up to select
work mode.
1
3
A
5. If "Side switch setup" is set to "Auto" or "Extra 1/
Extra 2", use the side switches on the joysticks as
shown in the illustration. Refer to
page 38 .
1401 - 002 - 15.10.2021
"Joystick setup" on
6. If "Side switch setup" is set to "Off", use the right
joystick as shown in the illustration below.
1
2
Position
Use
1
"Extra function 1": To select direction 1 of
the hydraulic oil.
2
"Extra function 1": To select direction 2 of
the hydraulic oil.
3
"Extra function 2": To select direction 1 of
the hydraulic oil.
4
"Extra function 2": To select direction 2 of
the hydraulic oil.
To operate the outriggers
1. Push the operation mode switch (A) down to select
transport mode.
B
1
C
3
A
2. Do the procedure that follows for one lever control:
a) Turn the transport mode switch to one lever
control (B).
3
4
61
Advertisement
