Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions page 204

Symptom Cause/possible source
There is an unusual
smell.
Fumes are emitted from
the battery.
Table 57: Error solution for battery
9.1.5 On-board computer error
Symptom Cause/possible source
The battery charge level may be insuf-
ficient.
Is the power switched on?
No data are shown on the
Is the battery charged?
monitor when you press
the on-off button on the
battery.
Is the connector fitted to the power
cable correctly?
A component may be connected which
the system is unable to recognise.
The gear level is not
The gear level is only shown if the
shown on the on-board
electronic gear shift is used.
computer.
The product is designed in such a way
The settings menu that the settings menu cannot be
cannot be opened while opened if the system detects that
you are pedalling. someone is riding the pedelec. This is
not a malfunction.
The time display is The on-board computer battery has
flashing "0:00". come to the end of its service life.
Table 58: On-board computer error solution
9.1.6 Lighting does not work
Symptom Cause/possible source
The front light or rear light
The basic settings in the electric drive
does not go on, even
system have probably been configured
when the switch is
incorrectly. The light is defective.
pressed.
When the main beam is
switched on, the light
The motor is wired incorrectly.
goes off when the brake is
applied.
Table 59: Lighting error solution
MY22Z01 - 12_1.0_25.07.2022
Troubleshooting, fault clearance and repair
Remedy
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
Remedy
1 Charge the battery.
2 Switch on the power.
 Press the on-off button to switch the power on.
 If the battery is fitted to the pedelec and is being charged, it
cannot be switched on. Interrupt charging.
 Check that the power cable connector has not been
disconnected. If this is not the case, contact your specialist
dealer.
 Contact specialist dealer.
 Check that the power cable connector has not been
disconnected. If this is not the case, contact your specialist
dealer.
 Stop pedelec and change settings.
 Contact specialist dealer.
Remedy
1 Take pedelec out of service immediately.
2 Contact specialist dealer.
1 Take pedelec out of service immediately.
1 Contact specialist dealer.
203