HP xw4300 Installation Instructions

Rack mount tray kit

Hide thumbs Also See for xw4300:

Download this manual See also: Troubleshooting Manual, Technical White Paper

Rack Mount Tray Kit Installation

This document describes how to install a rack mount tray on an HP xw4200/4300 Workstation, and how to

mount the workstation in a rack.

Kit Contents

The following parts are shipped with this kit:

■ Rail Assembly

■ Rack Guide Strips

■ M5 and M6 Hardware Packets

■ Rack Mount Template Card

■ T-15 and T-20 Torx drivers

■ Cross-tip driver

Rack Mount Tray Kit Installation

HP xw4200/4300 Workstation

Page 1 of 4

■ Warranty Card

■ Rack Mount Installation Instructions

■ Rack Mount Tray

Page 1: Kit Contents
Rack Mount Tray Kit Installation HP xw4200/4300 Workstation This document describes how to install a rack mount tray on an HP xw4200/4300 Workstation, and how to mount the workstation in a rack. Kit Contents The following parts are shipped with this kit: ■...
Page 2 Attach Rack Mount Tray to Workstation 1. Using a T-15 Torx driver, remove the two middle chassis screws 1 from the rear of the workstation and set them aside for reuse. 2. Place the workstation 1 in the tray 2. Guide the front bezel of the workstation 3 forward, under the lip of the tray 4.
Page 3 Rack Mount Tray Kit Installation 3. Align the screw holes in the tray with the screw holes at the rear of the workstation 1. Fasten Tray to Workstation 4. Using a T-15 Torx driver, fasten the tray to the workstation with the two chassis screws set aside in Step 1.
Page 4 6. Using a cross-tip screw driver, secure the workstation to the rail mounting flanges with two M6 screws For product-specific information, refer to the Service and Technical Reference Guide for your HP Workstation at http://www.hp.com/support/workstation_manuals. © 2005 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. 405363-001...

Xw4200