Advertisement
1.
Clamp
2.
Positive battery lead
3.
Battery
4.
Negative battery lead
5.
Taillight coupler
6.
CDI unit coupler (6-pin)
7.
CDI unit coupler (3-pin)
8.
CDI unit coupler (6-pin)
CABLE ROUTING DIAGRAM
A.
Fasten the wire harness to the
upper engine bracket (left side).
Locate the clamp end facing to-
ward the upper side of the frame
with the tie end cut off on the in-
side of the frame.
2-25
B.
Fasten the wire harness to the
upper engine bracket (left side).
Locate the clamp end facing to-
ward the upper side of the frame
with the tie end cut off on the in-
side of the frame. Clamp the
wire harness at the marking.
C.
Pass the starter motor lead
through the hole in the relay
holder.
D.
Fit the cover securely.
Advertisement
