Turn On The Devices; Turn On The Power Of The Recorder - Panasonic i-PRO WJ-NX300K Installation Manual

5 Turn on the devices

Turn on the power of the recorder

Turn on the power of the recorder. When using the recorder for the first time, register the license for the recorder. (☞ Page 29)
Important:
• When using extension units, connect all the extension units to the power cords and turn on the power of all the extension
units before turning on the power of the recorder.
Step 1
Connect the provided power cord to the power cord
inlet on the rear panel of the recorder, and insert the
power plug to an outlet whose rating is as follows.
WJ-NX300K: 120 V AC, 60 Hz
WJ-NX300K/G: 220 V - 240 V AC, 50 Hz/60 Hz
→ The [OPERATE] indicator on the front of the recorder will →
light, the system check will start, and the startup window
will be displayed on the main monitor.
Important:
• Never turn off the power of the recorder during startup.
• Insert the power cord fully into the power supply terminal
so that it will not loosen or come out.
• Fix the power cord firmly at 15 cm to 20 cm {5-7/8 to
7-7/8 inches} from the plug with the provided power
cord clamp to prevent the cable from unplugging.
How to prevent power cord
disconnection
Fix the power cord at 15 cm to 20 cm {5-7/8 to 7-7/8 inches}
from the connector with the provided power cord clamp
passed through the clamp mount.
Clamp mount
① Pass the power cord clamp (accessory) through the
clamp mount.
②
15 cm ~ 20 cm
{5-7/8 ~ 7-7/8 inches}
② Tighten the power cord at 15 cm to 20 cm {5-7/8 to
7-7/8 inches} from the connector and fix it to the
clamp mount.
Cut the unnecessary part of the power cord clamp as
necessary.
Power cord clamp
①
27