Yamaha YITW12TXA Owner's Manual page 3

Wireless transmitter for ipod
Table of Contents

Advertisement

1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!: This product, when
2 IMPORTANT: When connecting this product to accessories and/or another
3 NOTE: This product has been tested and found to comply with the requirements
4 Compliance with FCC regulations does not guarantee that interference will not
5 Relocate either this product or the device that is being affected by the interference.
6 Utilize power outlets that are on different branch (circuit breaker or fuse) circuits
7 In the case of radio or TV interference, relocate/reorient the antenna. If the antenna
8 If these corrective measures do not produce satisfactory results, please contact the
9 The above statements apply ONLY to those products distributed by Yamaha
yitw12_om_U_caution.indd
FCC INFORMATION (for US customers)
installed as indicated in the instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved by Yamaha may void your
authority, granted by the FCC, to use the product.
product use only high quality shielded cables. Cable/s supplied with this product
MUST be used. Follow all installation instructions. Failure to follow instructions
could void your FCC authorization to use this product in the USA.
listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of this
product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if
not installed and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices.
occur in all installations. If this product is found to be the source of interference,
which can be determined by turning the unit "OFF" and "ON", please try to
eliminate the problem by using one of the following measures:
or install AC line filter/s.
lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable.
local retailer authorized to distribute this type of product. If you can not locate the
appropriate retailer, please contact Yamaha Corporation of America A/V Division
6600 Orangethorpe Ave., Buena Park, CA 90620.
Corporation of America or its subsidiaries.
1
i
En
2012/09/07
13:11:49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yit-w12

Table of Contents