Haier 43E4500R User Manual page 7

20. Wall or Ceiling Mounting – The appliance should be mounted to a wall or ceiling only as recommended by the
manufacturer.
21. Power Lines – An outdoor antenna should be located away from power lines.
22. Outdoor Antenna Grounding – If an outside antenna is connected to the receiver, be sure the antenna system
is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of
the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of
the mats and supporting structure grounding of the lead-in wire to an antenna-discharge unit, size of grounding
connectors, location of antenna discharge unit, connection to grounding electrodes and requirements for the
grounding electrode. See Figure below.
Note to the CATV System Installer: This reminder is provided to call the CATV system installer's attention to
Article 820-40 of the NEC, that provides guidelines for proper grounding and, in particular, specifies that the
CATV cable ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
23. Apparatus shall not be exposed to dripping or splashing. Do not place objects filled with liquids, such as vases on
the apparatus.
24. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE SYSTEM
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
ANTENNA
ANTENNA DISCHARGE UNIT
GROUNDING CONDUCTORS
5