Speaker; Removing The Speaker - Dell OptiPlex 7000 Micro Service Manual

Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket. Push the bracket to release
the bracket, and then lift the bracket out from the system.
NOTE: This step applies if you are upgrading the system with no expansion port.
2. Insert the optional I/O module into its slot from the inside of your computer.
3. Connect the I/O cable to the connector on the system board.
4. Replace the two (M3x3) screws that secure the optional I/O modules or two (M2x5) cross type screws that secure the
serial module to the computer chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in

Speaker

Removing the speaker

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
38 Removing and installing components
after working inside your
before working inside your
computer.
computer.