Cable Routing - Sanyo CCA-BC200 Instruction Manual

CABLE ROUTING

The following is an example when installing the camera on the rear spoiler.
CAUTION
•
Route the cable so that it does not block or obstruct vehicle operation.
•
Route the rear view camera cable as far away from the vehicle antenna as
possible to prevent noise interference with AM radio band reception. Also, route
the cable as far as possible from a TV antenna, if equipped.
•
Clean the areas where the cable clamps and waterproof pad are to be attached.
Wipe out oil, wax, moisture, dirt and dust with a cleaner and a clean cloth.
1. Route the camera cable along the top of the liftgate
and secure the cable with the cable clamps included
with the Rear View Back up Camera System.
Straighten the cable along the top of the spoiler (or
liftgate) and insert it through the opening at the side
of the liftgate.
•
Give the cable some slack to enable smooth
opening and closing of the liftgate.
2. Route the camera cable down to the lower part of
the liftgate and secure it with the cable clamps.
Route the cable to the outside of the liftgate hinge
and harness cover.
•
Route the cable carefully so that the cable is not
pinched when the door opens and closes.
•
Route the cable carefully to prevent water
penetration.
Camera
Need help? Call
1-800-421-5013
ECU box
Cable clamp
Camera
Cable
clamp
Harness cover
Hinge
Cable clamp
−15−
Control switch
Cable clamp
Cable clamp
Cable tie