Solid-State Drive - HP 11-be0 Series Maintenance And Service Manual

10. Lift the interior side of the system board up (1), and then remove the system board from the computer
(2)
Reverse this procedure to install the system board. Run the camera function test after the repair. For more
information, see

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-11 Solid-state drive description and part number
Description
256 GB
128 GB
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display assembly (see
3. Disconnect the battery cable from the system board (see
4. Remove the system board (see
Remove the solid-state drive:
From the removed system board, pull the drive away from the socket to remove it.
▲
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Basic camera function test on page
Display assembly on page
System board on page
30.
Preparation for disassembly on page
30).
Battery on page
39).
Spare part number
M11042-007
M11040-007
29).
44).