Camera Selection
1. Select the desired monitor. (Refer to p. 106 Monitor
Selection.)
2. Press the numeric buttons to select the desired camera
number (1 to 99).
3. Press the CAM (SET) button.
The selected camera's image will appear on the active
monitor. The CAMERA indicator will light up and the
selected camera number will appear on the LED dis-
play on the controller.
Note: If you select a wrong number, press the CLEAR
button to clear the input.
4. If the selected camera number is not valid, the PRO-
HIBITED indicator and the number on the LED display
will blink for about 3 seconds.
Return to Step 2 and select a new camera number.
5. To replace the currently selected camera with the next
higher-numbered camera , press the NEXT button.
6. To replace the currently selected camera with the next
lower-numbered camera, press the PREV button.
CAM SETUP
INDEX
RECORDER
STOP
STOP
SETUP
Note: The PROHIBITED indicator will light up, if the
camera is selected by an operator with higher prior-
ity. Control of the same camera is denied to an
operator with lower priority.
107
F1
ACK
RESET
SUSPEND
ALL RESET
F2
GROUP SEQ
TOUR SEQ
REW/FF
PREV
NEXT
STEP
PAUSE
PLAY
PAUSE
OSD
SHIFT