Figure 93
1. Cap (coolant reservoir)
2. Hot engine-coolant mark
3. Cold engine-coolant mark
4.
If the coolant level is low, remove the
coolant-reservoir cap and add the specified
coolant until the level it is at the cold mark (for a
cold engine) or hot mark (for a hot engine).
Note:
Do not overfill the expansion tank with
coolant.
5.
Install the coolant-reservoir cap.
6.
Close and latch the hood; refer to
Hood (page
40).
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (More
frequently in dirty operating
conditions).
Every 100 hours—Inspect the cooling system
hoses.
Every 2 years—Flush and replace the cooling
system fluid.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
3.
4.
5.
g378285
1. Latch
6.
7.
Closing the
40).
55
Open the hood; refer to
40).
Thoroughly clean all debris out of the engine
area.
Close and latch the hood; refer to
Hood (page
40).
Unlatch the rear screen and pivot it open
94).
Figure 94
Thoroughly clean the screen with compressed
air.
Rotate the 2 oil-cooler latches inward, and tilt
oil cooler
(Figure
95).
Opening the Hood (page
Closing the
(Figure
g004138
2. Rear screen