LG VDS-ST1AU Owner's Manual page 16

INSTALLATION
16
WARNING
• Manage and supervise children or pet animals to
prevent them from bumping into product and
falling, or clinging to the product.
• If you prefer not to install this kit immediately,
ensure that you keep it out of the reach of
children as this may pose a choking hazard.
• Do not use this kit for purposes other than the
installation of the charging station.
• When drilling holes for mounting of anti-tip kit,
use caution and wear gloves, protective clothing
& protective goggles to prevent personal injury.
• If there is a pipe (gas pipe, water pipe, pneumatic
pipe, etc.), an electric cable or an electric wire
behind the wall, do not install the product on
that wall.
1
Before moving the product to its final position,
decide on a proper position for installing the
wall fixing anchor
• Install the wall fixing anchor and the fixing
rack directly behind the product.
2
Insert the fixing rack into the loop at the end of
the string and insert the provided wall fixing
screw into the fixing rack screw hole.
5 cm
3
Drill a 4 mm wide and 44.5 mm deep hole at the
selected position on the concrete wall and
insert the wall fixing anchor into the hole. Fix
the fixing rack to the wall firmly using the wall
fixing screw.
4
Insert the nearest string into the slide knot and
form a loop as shown in the figure. Insert the
fixing rack into the loop and insert the product
fixing screw into the fixing rack screw hole.
5
Align the screw hole on the fixing rack with the
hole at the back of the product and fix the
fixing rack to the product firmly by fastening
the product fixing screw.
6
Adjust the length of the string on the slide by
pulling it in accordance with the gap between
the wall and the product.
CAUTION
• Do not tighten the wall fixing screw excessively.
Doing so may cause the wall fixing to become
loose and the product to fall, resulting in
personal injury or product damage.
• Use the fixing rack only if the wall is a concrete or
solid wall. If the wall is not solid and the product
falls, personal injury or product damage may
result.
• Do not insert the fixing rack into the loop in the
middle. Doing so may cause the slide to slip after