Haier DW-7777-01 Installation Manual page 17

Put cardboard under dishwasher until it is installed. The cardboard
4. Remove terminal box cover "H". Pull
appliance wires "I" through hole in terminal
box. Do not untie the knot in the wires.
If you are direct wiring: install a UL-listed/
CSa-certified clamp connector "j" to
the terminal box. If using conduit use a
UL-listed/CSA certified conduit connector. If
you are installing a power supply cord kit,
do so now and follow kit instructions.
5. Measure height of cabinet opening from
underside of countertop to floor where
dishwasher will be installed "K" (you
need the lowest point). Check chart for
that height opening. Put wheels "l" in the
required position. Turn both front leveler
legs to the same height.
Min Cutout
Height
34" (86.4 cm)
34 1/4" (87 cm)
34 1/2" (87.6 cm)
If the minimum cutout height is less than
34" (86.4 cm), the adjustable legs can be
removed for additional clearance. This will
allow the dishwasher to fit into a 33 4/5"
(85.9 cm) high cutout, but the dishwasher
will be more difficult to move into position.
If the wheels are removed, protect the floor
when moving the dishwasher.
hElpful TIp:
will help protect floor during installation.
Wheel Position
(See Illustration)
1
2
3
I
K
Number of Turns
on Front Leg
10
5
0
English
H
J
K
16